GT-50 USB Firmware update Instructions
Download Programmer here:
https://www.st.com/en/development-tools/stm32cubeprog.html
Mac OS special instructions:
Unzip File
Right click on SetupSTM32CubeProgrammer-2.X.0.app
Select Show Package Contents
Double click on MacOS
Double click on “SetupSTM32CubeProgrammer-2_X_0_macos” to execute it
Download GT-50: Firmware V14
Upgrade Instructions
Power the GT-50 via both the red and yellow wires (Master Switch ON)
Press and hold the center button. While holding the center button press and hold both the outer buttons until the GT-50 display clears, you are now in programming mode
Open the STM32CubeProgrammer application on your computer
Connect the USB cable from your computer to the GT-50
Choose USB in the upper right and refresh the port then “Connect”
Choose the “Erasing and Programming” tab on the left
Browse to the GT-50.bin file on your computer
Choose “Verify Programming” and “Run after programming”
Click “Start Program…”